Starting The Programme; Soaking Laundry; Adding Laundry; Cancelling The Pro- Gramme - Siemens WM14VPH4GB User Manual And Installation Instructions

Hide thumbs Also See for WM14VPH4GB:
Table of Contents

Advertisement

13.8 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a If you start a programme with act-
ive oxygen, the drum lights up
after the programme starts and the
mist that is created can be seen.
a After the programme has ended,
the display shows: -0-.
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/Re-
load.
To resume the programme, after
3.
the desired soaking time, press
Start/Reload.
13.10 Adding laundry
Note: If you a start a programme with
active oxygen, you cannot add any
laundry after the programme has
started.
Press Start/Reload.
1.
The appliance pauses.
appears, it is not pos-
Note: If
sible to add laundry.
When
goes out, it is possible to
add laundry.
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/Reload.
5.
13.11 Cancelling the pro-
gramme
Note: If you cancel a programme
with active oxygen, the door will re-
main locked for up to 25 minutes un-
til there is no longer any active oxy-
gen in the drum.
the active oxygen is being removed.
The door is then unlocked.
Press Start/Reload.
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 24
Remove the laundry → Page 31.
3.
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Start the Spin programme or se-
1.
lect a suitable programme for
draining.
→ "Programmes", Page 24
Press Start/Reload.
2.
13.13 Unloading the laundry
Open the appliance door.
1.
Remove the laundry.
2.
Basic operation en
and
flash while
31

Advertisement

Table of Contents
loading

Table of Contents