Table of Contents
Advertisement
Installation loca-
tion
Base
Wooden joist
floor
Kitchen unit
Against a wall
ATTENTION!
Residual water may freeze. Freezing
residual water may damage the appli-
ance and frozen hoses may burst.
Do not install the appliance out-
▶
doors or in areas where there is a
risk of frost.
Requirements
Secure the appli-
ance with fixing
brackets
→ Page 28.
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
cent cabinets.
Required niche
width: 60 cm.
Do not trap the
hoses between
the wall and the
appliance.
Installation and connection en
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Note: Keep the transit bolt screws
and the sleeves in a safe place for fu-
ture transport → Page 50.
Pull the hoses out of the holders.
1.
Unscrew
and remove
2.
screws for the transit bolts with a
WAF 13 wrench.
all 4
13
Advertisement
Table of Contents
