Installation And Adjustment - Haier HWM60-78 User Manual

* Total time: including the normal water inlet time and drain time. The total washing time may be influenced by
the water inlet pressure and water level.
* Spin time: From the moment the intermittent spinning starts to the moment it stops running (the time displayed
on spin digitron is from intermittent spinning to the moment before inertia spinning; the time displayed on the
time remain digitron is the total remaining time)
* In soaking, after water inlet it will perform soaking for about 10-40 minutes, then perform washing, rinsing and
spinning.
* In selecting "posthaste" program, the washing machine will set the complete procedures of water level
selectior, washing, rinsing and spinning automatically.
Push the "reserve" button to select suitable
reserve wash program
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing
procedure to be finished at reserved time, please push the " reserve " button to set the reserve wash program.
Refer to reserve button in Page 11 for selection
Page
Confirm the operation of reserve program
When the "reserve" function is activated, the indicator light of the program you have set
will be off. The "reserve (hour)" and "time remain" indicator lights will be on. During
reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
Push the "start/Pause" button
5 Close the lid
Using process Using process
RESERVE
the washing will be finished after 18 hours.
START
PAUSE
6 Finish washing
After Finishing wash
alarm automatically

Installation and adjustment

Please install and adjust the machine according to the requirement of the mannual.
It is very important to your security and correct operating the machine.
Install the inner cover component
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover,
aiming the inner cover shaft to the installation hole of the
corresponding outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the
corresponding outer tub cover shaft groove, then push
the another inner cover shaft into the corresponding
outer tub cover shaft groove. Please install to designated
position to guarantee there are no dropping or abnormal
sound in opening and closing of the inner cover, and the
operation shall be smooth. Do not dismount the inner
cover component after washing.
Install the bottom plate
After opening the package, please lean the washing machine
gently down on soft items (like towel cloth,blanket, etc.). Install
the bottom plate to the bottom of the machine with eight screws
by a cross screwdriver, then lift the machine up gently.
See to the figure:
Before Using Before Using
Outer tub cover
Outer tub cover
shaft groove
Inner cover shaft
Inner cover
Section • enlarging
Push
Front
Back
Bottom plate
Screw Soft object