Trouble-Shooting - Haier HT1600TXVE Operation Manual

Matters Needing Attention
8. The washing machine must not be used
in the open or in area of high moisture as
water droplets may form on electrical
components,Air dry the appliance if the
washing machine components become
wet.
10. Keep away from heat sources and di-
rect sunlight to prevent plastic and rubber
components from aging.
1. Make sure that the washing machine is
securely connected to the water supply,
take the necessory precautions or con-
tact the local service center if the con-
nection is poor or there is a water
leakage.
9. The washing machine should be place
in a well ventilated area maintaing a
space between walls or furniture.
11. During installation, ensure that the
electric cable is not trapped by the wash-
lng machine and avoid damage to the
electric cable.
2 Keep the door slightly open when the washing
machine is not being used. Never cover the ma-
chine with a plastic sheet.

Trouble-shooting

The following circumstances do not constitute problems. Do not contact the maintenance service
until the problem has been confirmed.
Problem
The washing machine fails to Poor connection to power supply
operate Power failure
Door is not properly closed (Err 1)
Program knob has not been switched on (it is not
turned past "0")
Washing machine cannot be filled Water tap is not turned on
with water Water pressure is less than 0.05Mpa
The inlet hose is kinked
Water supply failure
The program knob is not properly set
The door is not properly closed
The inlet hose filter is blocked
The program is not started
The machine is draining while is The height of the drainage hose is below 80cm (it
being filled should be within 80-100cm)
The drainage hose end is in water
Drainage failure Drainage hose is blocked
Drainage hose end is below 100cm above the floor
level
The filter is blocked
Strong vibration during spinning Not all packing bolts have been removed
Washing machine is located on an uneven surface or is
not level
Machine load is over 5kg.
Operation stops before completion Water or electricity failure
of a wash cycle Washing machine is in a soaking cycle
Washing machine gives an error message.
Excessive foam in the drum, which The detergent is not a low-foaming type or for manual
is spilled to the distribution drawer wash
Excessive use of detergent
Possible cause