Table of Contents
Advertisement
Service Manual
Service Manual
Model
No:LMA2120WPAB0
Chapter 6: MAINTENANCE SERVICE AND TROUBLE SHOOTING
6-1. Trouble alarm and solve method
The display shows F2.
The display shows EL.
Note: when the digital tube displays the abnormal symbol during working,it buzzs once in succession every two minutes
phenomena
●The spinning is intermittent when it starts.
●The wash procedure is paused.
●Push the PROGRAM button to select SPIN,but it
doesn't work.
●The pulsator pauses during water inlet in wash and
rinse.
●There may be some water flowing out of the drain
hose in the first use of the machine.
Is the pump filter blocked?
Is the drain hose set too low?
FA
Is the water level too high?
Is the laundry too much？
Open the pump filter and remove dirts
Push
The height of the end of the drain hose
should be between 900mm-1200mm
Open the front control board,check the connection of the
wire and the sequencer
Change the water level sensor
Change the sequencer
Check the water valve whether can be close
Drain away water,then run again
Put part of the laundry out,then
push the Start/Pause button.
●Balance the laundries to avoid slanting
●The cloth sensor is checking the cloth,it will add water after 48
seconds.
●The program is setting the drain time. Some time is needed before it
starts spinning.
●It is to avoid splashing during water inlet.
●It is the water remained in the factory inspection of performance.
16
Issue
Rev.
if
Exlpalanation
Advertisement
Table of Contents
