PCchips M765VMRT Manual page 16

1. Locate the Socket-370, FAN1, and JP4. Pull the locking lever
out from the socket and swing it to the upright position.
FAN1
2. On the processor, identify the pin-1 corner by noting that it has
a slight bevel.
3. On the Socket-370, identify the pin-1 corner. The pin-1 corner
is on the same side as the locking lever, closest to the top of
the lever when it is in the locked position.
4. Match the pin-1 corners and insert the Celeron processor into
the socket. No force is required and the processor should drop
into place freely.
5. Swing the locking lever down and hook it under the catch on
the side of the socket. This locks the processor in the socket.
6. Locate the jumper JP4. Use this jumper to select if you have
installed a Slot-1 processor or a Socket-370 processor. The
jumper settings are illustrated below.
1
JP4
Selects a Slot-1
processor
Install the Mainboard
Socket-370
Pin-1 Corner
1
JP4
1
JP4
Selects a Socket-370
processor
11