Bellini BOT608X Installation & Operation Instructions page 28

Electrlcal connection
This appliance must be
installed by a qualified person.
Before connecting the appliance, make sure that
the supply voltage marked on the rating plate
corresponds with your mains supply voltage.
220-240V a.c. 50Hz
WARNING: THIS APPLIANCE MUST BE
EARTHED.
Connecting the mains supply cable
• The mains terminal block is located on the
underside of the hob and the terminals are
accessible by removing the terminal block
cover by removing the cover screw.
• The cable connections must be in accordance
with the diagram located on the bottom of the
hob.
Hard Wired Appliances :
When making the mains supply conductor
connections to the terminal block within the terminal
box , please ensure that minimum clearances are
being maintained between individual conductors
and conductors/connectors to the adjacent metal
surfaces of the terminal box itself , where possible
add heat shrink sleeves to any bare conductor end/
connectors prior to securing.
Troubleshooting Guide
Problems
The hotplates
are not
functioning or
will not switch
on.
A humming
L
sound is heard
when a hotplate
is selected.
The hotplates
have become
discoloured
Only two of the
hotplates on
my cooktop are
working
IMPORTANT: If your appliance appears not
to be operating correctly, then you should
disconnect it from your mains supply and
then contact the Service Department .
DO NOT ATTEMPT TO REPAIR THE
APPLIANCE BY YOURSELF.
8
Possible Cause and
solve
Check that the mains
electrical supply to the
appliance is correct
and working. Check the
mains fuse.
This is normal; the
sound will disappear
when the hotplate heats
up
This maybe caused
by burnt on remnants
of food. This will not
affect the working of the
appliance. However you
should make sure that
the cleaning instructions
are being followed
regularly.
You should recheck
that the terminal screws
are all fully tightened
between the links.