Travis Industries 99300471 Quick Start Manual

Salish Bay DVS Face
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on
the carrier's freight receipt. Any damage claims as a result of shipping must be handled through the shipper.
Travis Industries will provide assistance in resolving shipping claims or replacing items not included in the
package. Please report any missing items immediately.
COMPATIBILITY
¥ DVS Insert
TOOLS REQUIRED
¥ 7/16Ó & 11/32Ó Open-End or Socket Wrench
PACKING LIST
¥ Face ¥ Brick Floor
¥ Control Knob Support Plate (with Lock Plate & Two (2) Screws)
INSTALLATION INSTRUCTIONS
! Turn the gas to the appliance off prior to conducting service. Disconnect power to the appliance.
1 Attach the control knob
extenders (see the
directions to the right).
2 Attach the control knob support and control knob lock plate following the directions below.
Loosen the two nuts above the gas control valve (used to
a hold the burner pan in place). Slide the control knob
support over the studs and tighten the nuts.
Control Knob Support
(included with face)
Travis Industries
¥ DVS Fireplace
¥ 5/16Ó Nutdriver
¥ Two Knob Extenders
The extenders are
different and must
correspond to the
knobs on the valve.
7/16" Wrench
Page 1 of 2
¥ 3/8Ó Nutdriver (for glass retainer nuts)
¥ Control Panel Extension Plate
¥ Two Mounting Brackets
Install the extension knobs over
the knobs on the gas control
valve. Rotate the knobs until they
lock in place.
Install the control
b
knob lock plate.
Control Knob
Lock Plate
Phillips Screwdriver
Part # 99300471
¥ Two 8-32 Nuts
¥ 4 Screws
Gas Control Valve
(located below firebox)
Printed 11/19/99