Safety Warnings - Gearmore SPEDOVATORS Operation & Service Manual

1.1

SAFETY WARNINGS

GENERAL WARNING:
Read this manual before starting to use the machine. EVERYTHING DESCRIBED IN THE
MANUAL CONCERNS YOUR SAFETY. When you are working, be always careful and on
the alert. Be aware of possible dangers.
REGULATIONS
Conform to the laws and regulations concerning you and your machine.
TRANSMISSION
Do not enter the driveshaft work area when it is moving.
CLOTHES
The use of clothes that are not proper for the work can injure you. Baggy suits can entrap in the
machine. Please wear protective clothes apt for the work such as a rigid helmet, safety shoes,
protective hoods, a close-fi tting boiler suit and industrial gloves. Keep your cuffs buttoned up.
Do not wear ties or scarves. If your hair is long, tie it up.
TOOLS
Always check that tools are in good condition and fi t for the purpose.
HYDRAULIC HOSES
Hydraulic hoses can provoke accidents. Regularly check these hoses and look for damaged
junctions, external surfaces worn out by rubbing or other reasons, bent or cracked hoses, and
anything else which may break the hoses and cause dangerous situations.
HOSES CONTAINING PRESSURED OIL
The hoses can contain compressed air even when the machine is turned off or set out from the
tractor. Before dismantling them, check on the diagram whether the pipe section contains
compressed air. In any case, dismantle the pipe very cautiously.
O-RINGS, GASKETS AND PIPES
If gaskets, o-rings, hydraulic hoses are installed in a wrong way or are damaged or worn out, they
can cause leaks or accidents. Do not use solvents or acids next to o-rings, gaskets, or hoses.
REPAIR WORK
Do not make repair work or any other maintenance work, which are not know.
TAMPERING
It is strictly forbidden to alter or tamper with parts of the machine, which may infl uence its regular
working.
OPERATOR
All checks, inspections, controls, maintenance work, and any other operation shall be performed
when the machine is not running and the main switch is off, unless the contrary is explicitly
specifi ed in this manual.
3