Horizontal Adjustment - Gearmore SPEDOVATORS Operation & Service Manual

TURN OFF THE ENGINE BEFORE PERFORMING THE FOLLOWING OPERATIONS!!!

6.8.2 HORIZONTAL ADJUSTMENT

The sensing device rod is also provided with a horizontal adjustment.
The sensing device rod shall be installed at about the middle of the set of discs (in line with
its axis).
If big bushes or big harmful plant trunks have been removed, the sensing rod can be placed
in a higher position in order to allow the set of discs to uproot bushes instead of digging them
out by hand.
This adjustment can be prearranged also when deeper discing operations have to be performed.
To perform the horizontal adjustment act on the two fastening screws (Fig. 14, pos. 4) of the
sensing device rod clevis (Fig. 14, pos. 3). When the rod has reached the best position, tighten
the two screws fi rmly.
Fig. 14
27