Pto Driveline Installation - Gearmore SPEDOVATORS Operation & Service Manual

6.4 PTO DRIVELINE INSTALLATION

TURN OFF THE ENGINE BEFORE PERFORMING THE FOLLOWING OPERATIONS!
Before installing the driveline, make sure that the engine of the tractor has been switched off, that the
switch key has been taken away and that it can not be started beyond the control of the operator who is
installing the equipment.
To set up the equipment, follow these directions:
~ Carefully clean the slots of both the tractor and the equipment PTO by means of cloths or
brushes. Then oil or grease. (Fig. 09).
~ Make sure there are no foreign matters in the hole splines of the driveline and, if necessary,
remove the dirt, then oil or grease.
~ The little tractor printed on the label shows the side of the tractor transmission.
~ Insert the driveline on the spline shaft of the tractor and of the equipment. Press the push
button and drive the fork hub onto the PTO so that the push button comes to its original
position after the PTO fi xing (Fig. 10a).
~ Fix the chain free end to one of the holes of the tractor frame by means of its proper locking
bolt, so that the drive articulation is allowed under any working and transport condition.
Make sure that nothing has been placed on or twisted around the cardan joint.
Make sure that the fi xed safety guards of both the tractor and the equipment have been correctly
installed and are not damaged. (Fig. 10b) and (Fig. 10c)
GEARMORE DECLINES ANY RESPONSIBILITY FOR INJURIES TO PEOPLE AND/OR DAMAGE
TO THINGS DUE TO THE WRONG INSTALLATION AND FIXING OF THE CARDAN JOINT.
23
Fig. 09
Fig. 10b
Fig. 10a
Fig. 10c