Manual /Electric Control Installation - Gearmore SPEDOVATORS Operation & Service Manual

Tension the stabilizing chains of the tractor lifting unit and set the position of the arms in
4.
order to center them in the center of the machine itself.
Leave the equipment in this position, raise completely the lateral stands until they reach
5.
their highest position, insert the check pins and hook the safety devices against the set of
discs sliding out. (Fig. 07).
Lower the implement until the back wheels rest completely on the ground.
6.
TURN OFF THE ENGINE OF THE TRACTOR
6.3 MANUAL OR ELECTRIC CONTROL INSTALLATION
Manual controls (Fig. 08a, pos. 1) are delivered coupled to the machine through the clevis pos. 2 in
order to be correctly positioned during the transport. To install the tractor, take off the unit upwards and,
by means of the proper clevis (pos. 2), place it in the preset support (To be performed by the user) placed
beside the driver's seat.
Electric controls (Fig. 08b, pos. 3) are delivered packaged. The control board is provided with a 12
Vcc outlet (pos. 4) to be connected to the tractor, and with the male plug (pos. 5) to be connected to the
female connector (pos. 6) of the hydraulic solenoid valves.
Should the voltage be different or in case of doubt, apply to our After-Sale Service.
Install the machine by means of the proper clevis (pos. 7) and place it in the preset support (To be per-
formed by the user) placed beside the driver's seat.
THE OPERATOR SHALL BE ABLE TO REACH THE CONTROLS FROM THE DRIVER'S SEAT
OF THE TRACTOR.
Fig. 08a
Fig. 08b
Fig. 07
20