Manual Control Unit Functions - Gearmore SPEDOVATORS Operation & Service Manual

6.3.1 MANUAL CONTROL UNIT FUNCTIONS

Should you have any doubt, apply to our After-Sale Service.
IMPORTANT:
ONLY QUALIFIED PERSONNEL SHALL OPERATE ON THE HYDRAULIC COMPONENTS,
EVEN TO PERFORM STAGES OF LITTLE IMPORTANCE.
⇒
Turn off the engine and disconnect the pump before operating on the hydraulic system.
POSSIBLE DAMAGES CAUSED BY WRONG OPERATIONS ON THE HYDRAULIC
SYSTEM ARE NOT UNDER WARRANTY.
After having installed both the control unit and the equipment according to all the directions stated in
the previous paragraphs, read the following instructions (Fig. 08d) and look up the hydraulic system
diagram to perform the preset controls:
~ To raise the "head unit" hold the lever (pos. B) outward. To
lower it, hold it down inwards. To stop the head unit in an
intermediate position, release the lever (in its steady central
position).
~ To let the "set of discs go back manually" press the lever
(pos. D). To reset, release the lever.
~ To perform the "unit sliding out" hold the lever (pos. C) down
outward. To let it go back, hold it down inwards.
~ To perform the set of discs clockwise "rotation" press outwards
the lever (pos. A). To perform the counterclockwise rotation,
press it inwards.
Be careful! The lever Pos. "A", after having been operated, holds its position, therefore reset it in its
central position (neutral) to stop the set of discs rotation.
DO NOT OPERATE THE SET OF DISCS ROTATION CONTROL placed on the control
unit, when the set of discs is not working.
DO NOT OPERATE THE SET OF DISCS ROTATION CONTROL placed on the control
unit, if the set of discs has been raised from the ground.
Before performing any maneuver, even to test them, read carefully this manual and pay attention to the
instructions and directions of the paragraphs concerning the above mentioned control functions.
21
Fig. 08d