Service Test Mode; Speci Fi Cations - GE GLDT690T Technical Service Manual

Built-in dishwasher with top controls
Hide thumbs Also See for GLDT690T:
Table of Contents

Advertisement

https://appliancetechmanuals.com

Service Test Mode

To enter the service test mode:
Turn the dishwasher off and make sure no LEDs are lit .
Disconnect power to the dishwasher.
Reapply power with the door open and quickly press and hold both the Delay and ON/ OFF pads within 3
minutes from connecting power.
If performed correctly , all LEDs and the SSD will
factory diagnostic mode, either press the ON/ OFF button or wait for all steps to
Steps 1-5 of the service test mode can be performed with the door in either an open and closed state. Steps
6-11 will only progress if the door is closed. If the door is open during steps 6-11, the AC Load will turn off
immediately while the respective LED/ SSD display s remain on. Pressing Select during a step will force the
control to skip to the next step.
Step
1
Turn ON all LEDs and Beeper
2
Turn OFF all LEDs
Display SW Version
4
Display Error code
5
Dispaly Error code
Displa
6
Turn on water Valve
W
Turn on Main Pump
Turn on Dispenser
9
Turn on Main Pump + Heater
10
Turn on Drain Pump
11
Display machine type
12
Turn OFF all Components and LEDs
Error Codes: E0 - Thermal Sensor Cut
NOTE: Service mode will automatically turn o after progressing through all steps
Speci
cations
Electrical Supply (Under Load)
Supply Water Flow Rate
Supply Water Temperature*
Water Charge
Spray Arm Rotation
*Before starting dishwasher, run the water at the sink faucet until hot .
ash every second until the next step is selected. To exit the
Action
Blank
0A - FF
E0 or E1 or 00
E0 or E1 or 00
15 Sanitize LED
14 Heavy LED
1 Normal LED
12 Light LED
11 Glasses LED
C5
Blank
E1 - Thermal Sensor Short
60 Hz - 120VAC + 10%
Must
ll 0.85 gallon container in
30 seconds
120 to 150°F (49 to 66°C)
0.85 gallons (3.2 liters). This water
level can be measured at 0.4"
below the top surface of the
manual
20 to 60 RPM
Duration
Indicator
s for LED s
s
5s
5s
5s
0s
60s
60s
60s
60s
5s
Beeper 00 ms
lter.
– 32 –
nish.
Door Position
s
Door may e open or
closed for these steps
Door must e closed for
these steps
Door may e open or
closed for these steps

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gldt696t

Table of Contents