Overview Of Cy Cles - GE GLDT690T Technical Service Manual

https://appliancetechmanuals.com
SSD (Seven
Segment
Display)
• After pressing the ON/ OFF button, all LEDs will light , the digital display will show 88 , and the buzzer will
beep.
• The estimated cy cle time will be display ed as a two-digit number. If the cy cle time exceeds 99 minutes,
the seven segment display will show 2H . If the cy cle time is less than or equal to 99 minutes, the actual
estimated cy cle time is display ed.
• The control makes an End-of-Cy cle Alert for 1 second every 2 minutes (with a maximum of 4 beeps) for
any mode (regardless of whether delay was selected or not) after the end of any cy cle.
• Cancel/ Change cy cle: After a cy cle has started, open the door and hold the Select button down for 3
seconds. After 3 seconds, the machine will beep and the display will select the next cy cle to the right . If
left on any cy cle with the door closed, the machine will drain and start that new cy cle automatically .
• Delay start – Select 1 to 24 hours as the amount of time to delay the start of the cy cle. This will be
display ed as 1H , 2H , etc. The delay start display never shows minutes.
• When the door is closed, the display will turn off after 3 minutes regardless of a time delay . Opening the
door will turn the display back on. During the cy cle run, the selected cy cle LED will
• This model does not contain a Demo mode.
Sanitize wash cy cle de
The Sanitized LED will only be turned on at the end of the sanitize wash cy cle if the following two conditions
are met during the cy cle:
1. An internal calculation the board makes based on several heat factors.
2. The water temperature in the
The maximum time for the
are met prior to the 60 minute limit , the
Clean LED will turn on. If either condition is not met at the end of the 60 minute limit , the
and the Sanitized light will not turn on.
Overview of Cycles
fi
nition:
fi
nal rinse is greater than or equal to 150°F.
fi
nal rinse in the sanitize wash cy cle is 60 minutes. If both of the above conditions
fi
nal rinse will end immediately and both the Sanitized light and
– 9 –
fl
ash on/ off.
fi
nal rinse will end
( Continued next page )