Service Test Mode; Specifi Cations; Diagnostics And Service Information; Thermistor - GE GLDA690 Technical Service Manual

Diagnostics and Service Information

Service Test Mode

This dishwasher is programmed with a service test mode to aid the technician in troubleshooting. Certain
components can be independently activated.
To enter the service test mode, the dishwasher must be in the standby mode. Press the Light Wash and
Delay Hours keypads simultaneously and hold for 3 seconds.
COMPONENT ACTIVATED
MOTOR PUMP
DRAIN PUMP
DETERGENT/RINSE MODULE
WATER VALVE
HEATING ELEMENT
To exit the service test mode, press the START/RESET keypad at any time.
Specifi cations
Electrical Supply (Under Load)
Supply Water Flow Rate
Supply Water Temperature*
Water Fill
Spray Arm Rotation

Thermistor

Water Valve
Dispenser Wax Motor
Wash Pump
Drain Pump
Heater
Heater Wattage
*Before starting dishwasher, run the water at the sink faucet until hot.
KEYPAD PRESSED
HOT START
HOT WASH
HEATED DRY
POTS & PANS
NORMAL WASH
120VAC + 10%
Must fi ll 1.05 gallons container in
36 seconds
120°F to 150°F (49°C to 66°C)
1.05 gallons (4 liters)
20 to 60 RPM
56.5K Ω at 72°F
1036 Ω
2.6K Ω
17 Ω
27 Ω
21.2 Ω
Wet: 630 watts Dry: 465 watts
– 28 –
MAXIMUM ACTIVATION TIME
2 MINUTES
1 MINUTE
1 MINUTE
1 MINUTE
2 MINUTES