Related Manuals for Omcan Aurora DA-CN-0353
Summary of Contents for Omcan Aurora DA-CN-0353
- Page 1 Dry Aging Cabinet Model DA-CN-0353 Item 47101 Instruction Manual Revised - 12/07/2021 Toll Free: 1-800-465-0234 Fax: 905-607-0234 Email: service@omcan.com www.omcan.com...
-
Page 2: Table Of Contents
Table of Contents Model DA-CN-0353 Section Page Disclaimer -------------------------------------------------------------------------------------------- 3 General Information --------------------------------------------------------------------------- 4 - 5 Safety and Warranty --------------------------------------------------------------------------- 5 - 8 Technical Specifications -------------------------------------------------------------------------- 8 Installation -------------------------------------------------------------------------------------- 8 - 12 Operation ------------------------------------------------------------------------------------- 12 - 17 Troubleshooting ----------------------------------------------------------------------------- 17 - 19 Parts Breakdown ---------------------------------------------------------------------------- 20 - 21 Electrical Schematics... -
Page 3: Disclaimer
Disclaimer OMCAN IS NOT RESPONSIBLE FOR DIMINISHED COOLING OR ANY DAMAGES DUE TO WATER LEAKS. WARRANTY IS VOID IF THE AMBIENT ROOM TEMPERATURE EXCEEDS 75°F AND 55% RELATIVE HUMIDITY, AND THE APPLIANCE DRAIN IS NOT CONNECTED DIRECTLY TO A FLOOR... -
Page 4: General Information
If the package has suffered rough handling, bumps or damage (visible or concealed), please note it on the bill of lading before accepting the delivery and contact Omcan within 24 hours, so we may initiate a claim with the carrier. A detailed report on the extent of the damage caused to the machine must be filled out within three days, from the delivery date shown in the shipping documents. -
Page 5: Safety And Warranty
Si el paquete ha sufrido un manejo de poco cuidado, golpes o daños (visible o oculto) por favor anote en la factura antes de aceptar la entrega y contacte Omcan dentro de las 24 horas, de modo que podamos iniciar una reclamación con la compañia. - Page 6 Safety and Warranty defects of the cabinet. Warranty applies to the cabinet only and not to the content of the cabinet • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Page 7 1 YEAR PARTS AND LABOUR BENCH WARRANTY Within the warranty period, contact Omcan Inc. at 1-800-465-0234 to schedule a drop off to either an Omcan authorized service depot in the area, or to an Omcan Service warehouse to repair the equipment.
-
Page 8: Technical Specifications
Safety and Warranty Unauthorized maintenance will void the warranty. Warranty covers electrical and part failures, not improper use. Please see https://omcan.com/disclaimer for complete info. WARNING: The packaging components (cardboard, polyethylene, and others) are classified as normal solid urban waste and can therefore be disposed of without difficulty. -
Page 9: Installation
Installation environmentally friendly and can be reused. Please assist: dispose of the packaging according to environmental protection requirements. 2. To first understand the current waste disposal channels, please consult your professional distributor or local government agency. 3. If you want to dispose of the product, please do the following: remove the glass door, remove the shelf to prevent children from climbing, remove the door seal, to avoid accidents when children enter into play. - Page 10 Installation Warning: Risk of fire or flammability! ATTENTION: When the cabinet is at “OFF” condition: • Please take out all of goods from cabinet. • Please keep cabinet clean. Allow 24 hours before switching on the cabinet. During this time we recommend that you leave the door open to clear any residual odors.
- Page 11 Installation to avoid problems of this nature. 8. Air vent on door must be provided for built-in cabinet when a wood door installed. In hot climate zone, an air vent or grid, with a minimum ventilation size of 200mm x 40mm MUST be cut out at the rear top of the back partitioning or at the top of either side of the partitioning, allowing cool fresh air full access to flow into the 30mm gap located at the rear of the cabinet.
-
Page 12: Operation
Installation install the door on the opposite side of the cabinet (Drawing 5). 7. Finally, install the decorative nail and drop-proof device at the opposite side (Drawing 6). HANDLE INSTALLATION METHOD Note: Not all products need to install handles by themselves, please follow the configuration of the actual purchased product. - Page 13 Operation cabinet for the first time (or restart the cabinet after having it shut off for a long time), there will be a few degrees variance between the temperature you have selected and the one indicated on the LED readout. This is normal and it is due to the length of the activation time.
- Page 14 Operation good marbling. 6. Hang the complete back on the hangers of your cabinet or put the individual cuts on the shelves. 7. Load capacity: max. 2x half strip loins on the bone with a length of 0.5m, therefore you will need 2 hangers. 8.
- Page 15 Operation 2. Manual control: The cabinet is power on. Please press this button 3 seconds, the UV light will be always on. Please press light button 3 seconds again, and then the UV light will turn off. 3. When the UV light turn on, the UV light will be closed when door is open, and it will be on when door is closed.
- Page 16 Operation INSTRUCTIONS FOR ADDING WATER AND REPLACING ABSORBENT COTTON Note: The unit has automatic water adding function. VERY IMPORTANT NOTICE: There must be pure water near the unit’s location. Before you use the cabinet, connect the water inlet pipe 3 first and then open the inlet valve 1 to confirm that there is water entering the water tank.
-
Page 17: Troubleshooting
Operation 2. Drain cover operation diagram. The water tank baffle according to the view operation, and unplug the connecting wires and take-overs connected to the fan, water inlet pipe, etc. on the water tank. 3. Remove the absorbent cotton. Take out the water tank assembly and update the absorbent cotton. Troubleshooting OPERATION ANOMALIES Ensure that there is power to the electrical supply plug by connecting another electrical appliance to it. - Page 18 Troubleshooting revert to a preset temperature setting. Most power failures are corrected within a short period of time. An hour or two’s loss of power will not affect cabinet’s temperatures. To avoid sudden change of temperature while the power is off, you should avoid opening the door.
- Page 19 Troubleshooting The cabinet seems to make too much The rattling noise may come from the flow of the refrigerant, which noise. is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your cabinet. Contraction and expansion of the inside walls may cause popping and crackling noises.
-
Page 20: Parts Breakdown
Parts Breakdown Model DA-CN-0353 47101... - Page 21 Parts Breakdown Model DA-CN-0353 47101 Item No. Description Position Item No. Description Position Item No. Description Position AI456 Carton Box for 47101 AI472 Lock End for 47101 AI488 M10 Cabinet Leg for 47101 AI457 M5 Trunk-Nail for 47101 AI473 Magnet Mounting Box for 47101 AI489 Magnetic Switch Box for 47101 AI458...
-
Page 22: Electrical Schematics
Electrical Schematics Model DA-CN-0353 47101... -
Page 23: Warranty Registration
Warranty Registration Thank you for purchasing an Omcan product. To register your warranty for this product, complete the information below, tear off the card at the perforation and then send to the address specified below. You can also register online by visiting: Merci d’avoir acheté... - Page 24 Since 1951 Omcan has grown to become a leading distributor of equipment and supplies to the North American food service industry. Our success over these many years can be attributed to our commitment to strengthen and develop new and existing relationships with our valued customers and manufacturers.