Download
Share
Print this page
  1. Manuals
  2. Brands
  3. 3nStar Manuals
  4. Barcode Reader
  5. PTE0905-MSR
  6. User manual

3nStar PTE0905-MSR User Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
PTE0905-MSR
U
s
e
r
'
s
M
a
n
u
a
l
U
s
e
r
'
s
M
a
n
u
a
l
Version 1.0
i

Advertisement

loading
Need help?

Need help?

Do you have a question about the PTE0905-MSR and is the answer not in the manual?

Questions and answers

Related Manuals for 3nStar PTE0905-MSR

Summary of Contents for 3nStar PTE0905-MSR

  • Page 1 PTE0905-MSR Version 1.0...

  • Page 2: Table Of Contents

    3-1 Utility Setup 3-2 SeIect Interface 3-3 Firmware version 3-4 General setting 3-5 Pre/Postamble 3-6 Track Setting...
  • Page 3  Chapter 1 Specifications Basic Unencrypted (Default) Encrypted Information Card Types Magnetic Cards as per ISO7810, 7811, AAMVA Read Capability Magnetic Stripe - Triple Track of Low / High coercivity Card Handling Manual Swipe, Bi-Directional Method Card Thickness 0.76 ±0.08 mm Blue/ One Beep LED &...
  • Page 4  Chapter 2 MSR installation 1. Make sure the system is powered off. 2. Remove the right side cover of the PTE0905 3. Install the MSR into USB Type-A Connector of POS, and tighten two screws to fix the device (see the yellow circle below). 4.

  • Page 5: Chapter 3 Utility User Guide

     Chapter 3 Utility User Guide 3-1 Utility setup 1. Decompress the file: MagSwipe_Cfg_v2.3.5_A.rar 2. Click InstallerPackage 3. Choose setup “Next” 4. Click...
  • Page 6 5. Click “Yes” 6. Click “Yes” “Next” 7. Click...
  • Page 7 “Next” 8. Click “Next” 9. Click...
  • Page 8 Click “Next” Click Finish (Setup completed)

  • Page 9: Seiect Interface

    3-2 Select Interface ‧Choose the correct interface 3-3 Firmware Version ‧Click the “Check current reader setting”...

  • Page 10: General Setting

    3-4 General Setting 1. Change Beeper Behavior/MSR Reading function/Decoding Method, and click “send to MSR”. 2. Click “OK”...

  • Page 11: Pre/Postamble

    3-5 Pre/Postamble 1. If you want to change your track start/end sentinel, the ISO standard specification is 7 bits for Track 1, 5 bits for Track 2 and 5 bits for Track 3. 2. There are the settings for prefix and suffix which can be based on your own preferences, and then click “send to MSR”.

  • Page 12: Track Setting

    3. Click “OK” 3-6 Track Setting 1. The default is “Any Track”, but you can choose the number of tracks what you need, and then “send to MSR”.
  • Page 13 2. Click “OK”...