Table of Contents
Advertisement
B) Fiberglass Pools / Vinyl Pools Installation
1 Refer to section"Preparing to Install".
)
2) Make 2 holes on the pool wall (Figure 8).
3) Place the o-rings between the Mounting Plate and the pool wall and tighten it with the Nut on the other side of
the pool wall (Figure 9).
4) Put the cable sequentially through the sealing Nut, the sealing O-ring and the cable hole on the mounting plate;
then tighten the Nut (Figure10).
5) Wrap extra cables behind the light to make sure it could be taken to the pool surface for future maintenance.
Then, hang the light onto the Mounting Plate and tighten the screws (Figure 11).
Figure 8
NS75/150
P100/CP100
TP100
C)
Assembly for CP100
1) Clean the O-ring installation position and put the O-ring. (Figure 12)
2) After install the O-ring. Put the transparency lid and then put the cover. (Figure 13)
3) While install the cover with the base, please to note that the sign of "TOP"from the base should meet with the
sign of "TOP" for the cover. (Figure 14)
4) Rotate to the station position and then to use screw driver that to tighten. (Figure 15)
5) For Unassembled, please to reverse the sequence.
Figure 12
6. MAINTENANCE OF THE LIGHTS
1. Do not leave the lights "on" above water for longer than 1 minute.
2. Before switching on the lights, check whether the lights are fully submerged underwater and the circuit boxes
are running properly.
3. This unit does not need any kind of maintenance. If it is not working properly, please contact EMAUX
authorized dealer where you purchase the unit from.
4. Warranty will be voided if the Emaux Underwater Light was dismantled by unauthorized personnel.
Figure 9
Mounting plate
Nut
O-ring
TP100
Figure 13
Figure 10
Figure 14
Figure 15
MAINTENANCE OF THE LIGHTS
Figure 11
P6
Advertisement
Table of Contents
