Care, Maintenance And Service - Heatscope SMARTBOX Original Installation And Instruction Manual

M U N I C H H O M E S Y S T E M S

CARE, MAINTENANCE AND SERVICE

Before cleaning and maintaining your HEATSCOPE SMARTBOX disconnect it from the power supply or,
®
if buried cables are used, switch it off via the omnipolar switches. All surfaces should be cleaned using
a damp cloth only.
Never use cleaning products containing alkaline substances such as sodium hydroxide or soap,
surfactants or solvents such as alcohol. Use only a very soft cloth or a brush for the reflector and the
heating elements.
EN
Changing the PCB is only permitted with original equpiment and must only be carried out by an authority
delegated by the manufacturer. Damage or defects caused by improper handling or operation as well as
defects caused by using nonoriginal parts or the use of accessories not recommended by the
manufacturer are not covered by the warranty.
REMOVAL FROM SERVICE / DISPOSAL
When the unit reaches the end of its life, it must be removed from service by a specialist in accordance
with the relevant regulations and steps must be taken to ensure that it cannot be put into use again.
The unit must be disposed of professionally and in an environmentally friendly manner. The relevant legal
regulations must be observed.
46
Technomac Sp. z o.o. • ul. Spadowa 3 • 04-669 Warszawa