Installation Instructions; Tools And Materials Required; Electrical Requirements - Haier HDE5000AW User Manual And Installation Instructions

English

INSTALLATION INSTRUCTIONS

Risk of Fire:
1.Clothes dryer installation must be performed by a qualified installer.
2.Install the clothes dryer according to the manufacturer's instructions
and local codes.
3.Do not install a clothes dryer with flexible plastic venting materials.
If flexible metal (foil type) duct is installed,it must be of a specific
type identified by the appliance manufacturer as suitable for use
with clothes dryers. Flexible venting materials are known to collapse,
be easily crushed,and trap lint.These conditions will obstruct clothes
dryer airflow and increase the risk of fire.
4.To reduce the risk of severe injury or death, follow all installation
instructions.

Tools and materials required

• Phillips-Head and flathead screwdrivers
• Channel-lock adjustable pilers
• 1/2-inch open-end wrench
• Carpenter's level
• Measuring tape (12ft. min.)
• Duct tape
• Pipe thread sealer (Gas)
• Rigid or flexible metal 4 inch (102cm) duct
• Vent hood
Safety Warning:
1. Before starting installation, make sure that the gas shut off valve is in the
off position.
2. All old gas connectors and gas piping should be discarded.

ELECTRICAL REQUIREMENTS

Electric Dryer:
Circuit
Individual 30 Amp branch circuit fused with 30 Amp time-delay fuses or circuit
breakers. Use seperately fused circuits for washers and dryers, and DO NOT
operate a washer and dryer on the same circuit.
5
WARNING
SAVE THESE INSTRUCTIONS
(CHDE/HDE5000AW and CHDE/HDE5300AW)