Specifications; Packing List - Ego Power+ HT2410E Operator's Manual

◾
Do not use on a ladder, rooftop, tree, or other unstable
support. Stable footing on a solid surface enables
better control of the hedge trimmer in unexpected
situations.
◾
Never allow children to operate the hedge trimmer.
◾
Never remove or tamper with safety devices. Check
their proper operation regularly. Never do anything to
interfere with the intended function of a safety device
or to reduce the protection provided by a safety device.
◾
Never operate the hedge trimmer without proper guards,
plates, or other safety protective devices in place.
◾
Check damaged parts before further use of the hedge
trimmer. A guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced
by an authorised service center unless indicated
elsewhere in this manual.
◾
Check the blade and motor mounting bolts at frequent
intervals for proper tightness. Also, visually inspect
blade for damage (e.g., bent, cracked, and worn).
Replace the blade only with a blade from EGO
◾
Replace the blade if it is bent or cracked. An
unbalanced blade causes vibration that could damage
the motor drive unit or cause personal injury.
◾
If the equipment should start to vibrate abnormally,
stop the motor and check immediately for the cause.
Vibration is generally a warning of trouble.
◾
The trimmer shall be used to cut stems less than
26mm (HT2410E) / 25mm (HT2000E) thick.
◾
Trim only in daylight or in good artificial light.
◾
Remove or disconnect battery before servicing,
cleaning, or removing material from the hedge trimmer.
◾
Do not wash with a hose; avoid getting water in motor
and electrical connections.
◾
When servicing use only identical replacement parts
listed in this manual. Use of parts which do not meet
the original equipment specifications may lead to
improper performance and compromised safety.
◾
Follow instructions for lubricating and changing
accessories.
◾
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS!
56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER— HT2410E / HT2000E

SPECIFICATIONS

Model
Voltage
No-Load Speed
Blade Length
Cutting Capacity
Weight (without battery pack) 3.1kg
Recommended Operating
Temperature
Recommended Storage
Temperature
Guaranteed sound power level 92dB(A)

PACKING LIST

PART NAME
Hedge Trimmer
Shield
Operator's manual
TM .
DESCRIPTION
KNOW YOUR HEDGE TRIMMER (Fig. A)
1. Hanging hole
Tip protector
2.
Blade
3.
Hand guard
4.
Front handle
5.
Lock-off button
6.
Rear handle
7.
Battery-release button
8.
Latch
9.
Electric contacts
10.
11. Battery-mounting slot
12. Batter-ejection mechanism
Rear switch lever
13.
Front switch lever
14.
Hanging hole
15.
16. Sheild
WARNING:
completely assembled. The hand guard shall never
be removed during use. Once damaged, replace it
immediately by a qualified service technician.
HT2410E
56V
1500/min
61cm
26mm
0°C-40°C
-20°C-70°C -20°C-70°C
QUANTITY
1
1
1
This product has been shipped
HT2000E
56V
1500/min
51cm
25mm
2.9kg
0°C-40°C
7