Operation - Stanley ST-700-DR-E Instruction Manual

1. remove blower from packaging. be certain
no packaging materials are blocking the air
inlet (rear) or air outlet (front).
2. Place blower on level ground.
3. Connect blower to a grounded power outlet
with an approved power rating using a 14
awG or better power cord.
Model ST-700-DR-E:
4. Push power switch on top of blower to the
"oN" Position. (Figure 1)
Power Switch
Figure 1
Model ST-701-DR-E:
4. turn the control knob to the desired speed: 1,
2, 3. (Figure 2)
Figure 2
NOTE: the direction of moving air is indicated by
an arrow on the blower housing.
© 2016, Pinnacle Climate Technologies, Inc.
668 Stony Hill Road #302 Yardley, PA 19067

Operation

Power Knob
4
Moisture Control
this blower produces a flat air column which is
well suited for drying and evaporating excess
moisture from floors.
NOTE: this blower will not prevent mold or
mildew formation. to prevent mold or mildew
formation this blower should be used in unison
with a dehumidifier.
Ventilation and Cooling
this blower can drop the temperature of an
over-heated room by moving large quantities of
air rapidly.
Stacking
the housing is designed to stack one blower on
top of another. St-701-dr-E only (Figure 3)
aLwaYS be certain blower is on level ground
before stacking.
aLwaYS be certain the blowers are stacked
properly and securely before operating.
NEVEr stack more than two (2) blowers in a
single stack.
RISK OF INJURY! DO NOT
WARNING
MOVE BLOWER WHILE IT IS
OPERATINg!
Stacked blowers
(2 Maximum)
Figure 3