Subscribe to Our Youtube Channel
Related Manuals for USX-MOUNT XAS501-01
Summary of Contents for USX-MOUNT XAS501-01
- Page 1 XAS501-01 INSTRUCTION MANUAL If you have any questions along the way, just give us a call 1-800-460-0956 or message to us. We’re ready to help! USA-B0...
- Page 2 CAUTION: PLEASE READ ENTIRE MANUAL PRIOR TO USE AND SAVE THESE INSTRUCTIONS Before getting started, let’s check below lists to make sure it is just right for you! CAUTION: DO NOT exceed the maximum weight Does your speaker indicated. This mounting system is intended for use only Max: (including accessories) No? Perfect –...
- Page 3 Dimensions Product dimensions MAX:1450mm MAX:1175mm [57in] [46in] MIN:930mm MIN:880mm [36.5in] [34.6in] 362mm [14in]...
-
Page 4: Parts And Hardware
Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. - Page 5 Hardware for Speaker Installation Spacers Screws Washers Nuts M4x30mm M6x30mm Key Hole Bolt...
- Page 6 STEP 1 Choose rubber feet or carpet nails according to your floor type Option One: Rubber feet (pre-assembled on the product) for wooden, cement, tile or other hard floor. Adjust the rubber feet to level/adjust the base if the base is not level. Adjustable foot Option Two: If the stand is placed on carpet, remove the rubber feet first, install the carpet nail ( carpet...
- Page 7 STEP 2-1 Speaker Stand Assembly Insert the bottom tube ( ) into the base ( ) and lock it with the bolt ( ). Loosening the plastic nut, then insert the top tube ( ) into the middle tube ( ) and tighten the plastic nut.
- Page 8 STEP 2-2 Speaker Stand Assembly Insert the speaker bracket ( ) into the top tube ( ) and fasten it by bolt (...
- Page 9 STEP 3 Attach speaker to assembled stand (Option 1) For threaded mounting hole installation (the distance from mounting hole to the bottom of speaker should not exceed 300mm/11.8inch). According to your speaker's installation hole, choose screw ( ), spacer ( ) and M4 washer ( to attach it.
- Page 10 STEP 3 Attach speaker to assembled stand (Option 2) For keyhole installation: Pass the keyhole screw ( ) through the mounting hole of the speaker bracket ( ), and screw on the nut ( ) (no need to tighten). Hang speaker onto the keyhole bolt and then tighten the unt ( ).
-
Page 11: Step 4 Height Adjustment
STEP 4 Height adjustment By rotating the plastic nut, the height of the speaker stand can be adjusted from 34.5 inch to 46 inch. - Page 12 STEP 5 Manage the cable clamp Insert the cable clamp ( ) into the hole on the post tubes, orderly manage the speaker cables, guide them through the cable clamp (...
Need help?
Do you have a question about the XAS501-01 and is the answer not in the manual?
Questions and answers