Controller Address - H3C S7500E-XS Series Command Reference Manual

Predefined user roles
network-admin
Parameters
global: Specifies the global mode.
vlan: Specifies the VLAN mode.
vlan-id: Specifies the VLAN ID in the range of 1 to 4094.
vlan-mask: Specifies a VLAN mask in the range of 0 to 4095. The default value is 4095.
loosen: Specifies the loosen mode. If the loosen mode is used, a port belongs to the OpenFlow
instance when VLANs associated with the OpenFlow instance overlap with the port's allowed VLANs.
Otherwise, a port belongs to an OpenFlow instance only when VLANs associated with the OpenFlow
instance are within the port's allowed VLAN list.
Usage guidelines
The VLANs to be associated are calculated by a bitwise AND operation on the specified VLAN ID
and mask. The VLAN mask supports non-contiguous 1s and ignores all 0 bits. To view the
associated VLANs, use the display openflow instance command.
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Associate OpenFlow instance 1 with a list of VLANs determined by VLAN ID 255 and VLAN mask
7.
<Sysname> system-view
[Sysname] openflow instance 1
[Sysname-of-inst-1] classification vlan 255 mask 7
Related commands
display openflow instance

controller address

Use controller address to specify a controller for an OpenFlow switch and configure the main
connection to the controller.
Use undo controller address to remove the configuration.
Syntax
controller controller-id address { ip ip-address | ipv6 ipv6-address } [ port port-number ] [ local
address { ip local-ip-address | ipv6 local-ipv6-address } [ port local-port- number ] ] [ ssl
ssl-policy-name ] [ vrf vrf-name ]
undo controller controller-id address
Default
The main connection is not configured for an OpenFlow instance.
Views
OpenFlow instance view
Predefined user roles
network-admin
Parameters
controller-id: Specifies a controller by its ID in the range of 0 to 63.
2