H3C S7500E-XS Series Command Reference Manual page 15

Predefined user roles
network-admin
network-operator
Parameters
instance-id: Specifies an OpenFlow instance by its ID in the range of 1 to 4094.
controller-id: Specifies a controller by its ID in the range of 0 to 63. If you do not specify a controller ID,
this command displays information about all controllers for an OpenFlow instance.
Examples
# Display controller information for OpenFlow instance 100.
<Sysname> display openflow instance 100 controller
Instance 100 controller information:
Reconnect interval : 60 (s)
Echo interval
Controller ID
Controller IP address
Controller port
Local IP address
Local port
Controller role
Connect type
Connect state
Packets sent
Packets received
SSL policy
VRF name
Table 1 Command output
Field
Reconnect interval
Echo interval
Controller IP address
Controller port
Local IP address
Local port
Controller role
: 5 (s)
: 1
: 192.168.49.49
: 6633
: 192.0.0.1
: 5566
: Equal
: TCP
: Established
: 9
: 9
: --
: --
Description
Reconnection interval (in seconds) for an OpenFlow instance to reconnect to
all controllers.
Connection detection interval (in seconds) at which an OpenFlow instance
sends an Echo Request message to all controllers.
IP address of the controller.
TCP port number of the controller.
Source IP address of the controller that corresponds to an OpenFlow
instance.
Source TCP port number of the current controller.
Role of the controller:
•
Equal—The controller has the same mode as other controllers that are
specified for the OpenFlow instance.
•
Master—The controller is the master controller for the OpenFlow
instance.
•
Slave—The controller is a subordinate controller for the OpenFlow
instance.
If the controller is not configured with any role, this field displays two hyphens
(--).
8