Table of Contents
Advertisement
Automatically brings you to Status|Circuit screen for Circuit 1
Notice the Alarm Reset button is blinking red/orange.
Circuit will not reset until Ground-Fault condition does not exist.
Press on
to reset alarm.
LOW AND HIGH TEMPERATURE ALARMS
6.2.2
Using Dials on Front Panel
RTD Temperature, Heater Current and Ground-Fault Current for Circuit 3 and 4 can be
changed via the dials on the front panel. The following example can be applied to either
Circuit 3 or Circuit 4. For this example, Circuit 3 was used.
Low Temperature Alarm
Turn Circuit 3 Temperature dial to A on the front panel.
Notice ID and ºF in Red
IMPORTANT: After a 15-second timeout, the Acknowledge and Alarm light will turn
on.
nVent.com | 27
Advertisement
Table of Contents
