Table of Contents
Advertisement
The Network will then be updated with the connected devices, in this case with one NGC-
30-CRMS board, one RMM2 and one PLI-SES/SPC module.
When a PLI module is detected in the Update Network process, the PLI tab will be added
to the Network and Setup Sub-Menus.
IMPORTANT: For CRM/CRMS boards and RMM2 modules, the Resources Column
indicates the RTDs that are available for use in the Setup|RTD Screen. However, the
Resources Column for PLI-SES/SPC or PLI-TT indicates the maximum number of RTDs
that could be used. Please refer to heater isometric drawings for each circuit for the
assigned transmitters/RTD addresses to each circuit.
Step 4: Setting up a Circuit
Step 4A: Go to the Setup|Circuit screen.
At initial start-up, the Setup|Circuit screen automatically displays Circuit 1.
nVent.com | 13
Advertisement
Table of Contents
