Table of Contents
Advertisement
Step 3: Setting the Network for Device(s)
Go to the Network|Device screen.
For the very first time, the Network screen will be blank. See below.
Press "Update Network" and scan all NGC-30-CRM/-CRMS (5GF-C) boards, RMM2
and/or PLI modules into the network database. The Device Addresses for the NGC-30-
CRM/-CRMS (5GF-C), RMM2 and PLI module will be scanned and a database will be
created. A device address is the number assigned via the rotary switches on the NGC-30-
CRM/-CRMS (5GF-C) board, RMM2, PLI module.
Once the database exists, no further scanning is done unless the system is forced to
update the network by activating the "Update Network" button.
If a PLI (Power Line Carrier Interface) module is detected in the scanning process, a pop-
up window will open, asking whether the PLI Mode should be changed from the default
mode of PLI-SES/SPC to the PLI-TT. Since the PLI Module Demo Unit includes a SES
and SPC Transmitter, the option "NO" should be selected.
IMPORTANT: The NGC-30 Control System can support up to 4 PLI modules. Each
PLI module can support up to 127 SES or SPC transmitters and up to 255 700-TT
transmitters. The SES/SPC and 700-TT transmitters cannot be connected to the same PLI
module.
nVent.com | 12
Advertisement
Table of Contents
