Section − 5 Setting Ngc-Uit Program To Demo Mode - nVent RAYCHEM NGC-30 User Manual

Section − 5 Setting NGC-UIT Program to Demo Mode
This step needs to be completed just once on each Demo Unit in order to be used with
PLI module and standard operation. The PLI module works only with CRM boards. Since
the Demo Unit is configured as a CRMS board, this step is required to allow the PLI
module operation with the Demo Unit. We recommend that all Demo Units are set to the
Demo Mode since this step would not have any impact on the standard operation of the
Demo Unit.
5.1 Demo Mode Configuration Process
Step 1: Go to System|Password Screen
While the program is running, go to the System|Password screen and press "OK" for
entering a password.
Step 2: Enter Password
Select Level 1 Access. Enter the Password "DEMO". Save the new password and confirm
the saved password.
nVent.com | 9