Proper Use; Environmental Protection; Before Startup - Kärcher HD 10/21-4 Cage Manual

The appliance contains hot sur-
faces that can lead to burn inju-
ries.
Safety Devices
If the lever on the trigger gun is released
the pressure switch turns off the pump, the
high pressure jet is stopped. If the lever is
pulled the pump is turned on again.
The overflow valve prevents the permissi-
ble working pressure from being exceeded.
The overflow valve and pressure switch are
set and sealed at the factory. Setting only
by customer service.
Setting only by customer service.
The motor protection switch switches off
the device if the power consumption is high.

Proper use

Use this high pressure cleaner exclusively
for
For cleaning using high pressure jet
–
without detergent (for e.g. for cleaning
facades, terraces, garden appliances).
For stubborn dirt, we recommend the use of
the dirt blaster as a special accessory.

Environmental protection

The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for
disposal, but arrange for the proper
recycling.
Old appliances contain valuable ma-
terials that can be recycled. Please
arrange for the proper recycling of
old appliances. Batteries and accu-
mulators contain substances that
must not enter the environment.
Please dispose of your old applianc-
es, batteries and accumulators us-
ing appropriate collection systems.
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
www.kaercher.com/REACH
12

Before Startup

Check the contents of the pack before
–
unpacking.
In case of transport damage inform ven-
–
dor immediately
Check oil level
 Read the oil level display when the device
is not running. The oil level must be be-
tween the two markers on the oil reservoir.
Activate deaeration of oil container
 Cut off tip of oil container cover
Attaching the Accessories
 Install nozzle with nozzle screw at the
spray pipe.
 Connect spray lance to hand spray gun.
For hand-spray guns with threaded con-
nection:
 Tighten the high-pressure connection
as required.
For hand-spray guns without threaded
connection:
 Lever out the safety clip of the hand spray
gun using a screw-driver (Picture A).
 Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).
 Press the safety clip back into the hand-
spray gun. The hose can be pulled out
max. 1 mm if it has been installed cor-
rectly. Otherwise, it means the disc has
been installed wrongly (picture C).
EN
– 2
Unpacking