Table of Contents
Advertisement
Section IVA - OPERATING INSTRUCTIONS
4A.12 TOW FORK & ADAPTER APPLICATIONS
(a) Align Wheel Lift with disabled vehicle.
STEPS (b) THROUGH (d) ARE NOT NECESSARY
PERMITTING THE AXLE IS HIGH ENOUGH TO ALLOW
EXTENSION OF BOOM WITH FORKS AND ADAPTERS
(b) Extend the Boom (without adapters or forks) until crossbar
is centered with axle of disabled vehicle.
(c) Raise vehicle until tire can be blocked up high enough to allow
forks to clear axle when installed onto the crossbar.
(d) Block up tires and lower Boom until boom can be retracted
for installation of adapters and forks.
(e) Install adapters in desired configuration on crossbar. Select
and install desired forks into adapters. Refer to Figure 4A.19.
(f) Extend Boom until Forks are beneath axle or frame as desired.
(g) Manually adjust adapters on crossbar to a point where the
forks will come in contact with the frame or axle in the desired
towing position.
(h) Tighten "T" Handles on adapters. Attach safety chains
around axle or frame, crossbar and forks as shown in
Figure 4A.19.
WHEEL LIFT (cont'd)
NOTE
INSTALLED ON CROSSBAR.
IVA-14
Advertisement
Table of Contents
