Section III - OPERATIONAL FUNCTIONS
3.7 Before operating your wrecker, remove the Shipping Plugs from the
Winch Vent Cap. See Figure 3.5.
CHECK OIL LEVEL IN WINCHES BEFORE ANY OPERATION.
FILL TO PROPER LEVEL WITH REQUIRED GEAR LUBRICANT
AS NEEDED. REFER TO FIGURE 3.4 AND SECTION V,
MAINTENANCE FOR PROPER PROCEDURES.
3.8 Your wrecker is also equipped with Winch Free Spool Clutch
Controls located at each winch (manual) or on either side of the
wrecker body (air operated). These controls are used for allowing the
winches to freespool for payout of cable. See Figure 3.6.
WRECKER (cont'd)
FIGURE 3.5
NOTE
III-3