Table of Contents
Advertisement
Section IVA - OPERATING INSTRUCTIONS
4A.1
For reasons of safety, it is important that the Owner/Operator(s)
of the FORMULA III Wheel Lift become thoroughly familiar with
its controls, components and load requirements before
attempting any operation.
4A.2
CONTROLS
The Control Levers are located at the rear of the body on both
the left and right sides. All the controls are clearly identified as to
their function and direction. Refer to Figure 3A.1.
4A.3
PREPARING TO LOAD VEHICLE
(a) Line the Wheel Lift up with the center of disabled vehicle
to be towed. See Figure 4A.1.
(b) Reduce truck's engine to an idle and apply parking brake.
Depress clutch, place transmission in neutral and engage
PTO by pulling out knob located on the dash panel in truck
cab. Refer to Figure 4.1.
(c) Adjust engine speed to desired RPM using the Vernier
Throttle Control located on the left hand side of the wrecker
body.
WHEEL LIFT
FIGURE 4A.1
DO NOT EXCEED 1500 RPM
IVA-1
Advertisement
Table of Contents
