Table of Contents
Advertisement
Section IVA - OPERATING INSTRUCTIONS
4A.5
VEHICLE HOOK-UP (cont'd)
(d) Insert Tire Restraint into crosstube until it is firmly against
the rear of the tire. See Figure 4A.8.
(e) Engage Plunger and adjust the tire restraint until the plunger
engages in the appropriate hole in the tire restraint.
WITH TIRE RESTRAINTS INSTALLED, BE CERTAIN THAT
IT WILL CAUSE NO DAMAGE TO THE VEHICLE TO BE
TOWED WHEN WHEEL LIFT IS IN ITS RAISED POSITION.
TO AVOID ANY DAMAGE FROM THE TIRE RESTRAINTS,
ADJUST OUTER CROSS TUBES TO THE DESIRED POSITION
(f) Repeat procedures (c) through (e) on opposite side of vehicle.
(g) Take vehicle out of gear and make certain parking brake is
off.
(h) Using the Wheel Lift Lift "UP/DOWN" Control raise the
vehicle to desired towing height.
WHEEL LIFT (cont'd)
FIGURE 4A.8
NOTE
IVA-5
.
Advertisement
Table of Contents
