Compressor Diagnostic Codes - Doosan XHP1000WCAT-T4i Operation And Maintenance Manual

Operation & Maintenance Manual

Compressor Diagnostic Codes

Code
1
2
3
4
9
10
11
12
29
30
31
32
33
34
35
36
38
39
98
Display Name
Low Engine Speed
High Engine Speed
Engine Crank Timeout
Out of Fuel
Engine Diagnostic Code
Engine Speed Response
AutoStart Attempts
Exceeded
Low Fuel Level
Engine Shutdown
Unknown
High Airend Discharge
Temperature
Low Airend Oil Pressure
Airend Discharge
Temperature
Separator Tank Pressure
Sensor
High Separator Tank
Pressure at Start
High Separator Tank
Pressure
Safety Valve Open
Intake Air Filters
Restricted
Low System Voltage
Description
Engine speed less than 900 RPM for
30 seconds.
Engine speed greater than 1900 RPM
for 30 seconds.
Engine crank attempt longer than 15
seconds.
Fuel level in tank below usable limit.
Engine diagnostic code present in
ViewPort history log.
Engine target idle speed not met
within 10 seconds after loading
compressor.
Compressor not started after 3 crank
attempts.
Fuel level in tank approaching empty.
Engine stopped without an engine
diagnostic code.
Airend discharge temperature greater
than or equal to 248°F.
Airend oil pressure below 10 psi.
xx(HP Model only)
Airend discharge temperature sensor
reading out of range.
Separator tank pressure sensor
reading out of range.
Separator tank pressure greater than
20 psi at crank attempt.
Air pressure in the separator tank
exceeded limit.
Safety relief valve on separator tank
opened.
Intake filters restricting air flow.
Electrical system voltage below 25.5
VDC.
Troubleshooting
Code
Type
FAULT
FAULT
ALERT
FAULT
ALERT
ALERT
FAULT
ALERT
FAULT
FAULT
FAULT
FAULT
FAULT
ALERT
FAULT
FAULT
ALERT
ALERT