Lifting; Before Towing; Setting Up - Doosan XHP1000WCAT-T4i Operation And Maintenance Manual

Operating & Maintenance Manual

Lifting

The central lifting bail allows the compressor to be lifted from a single point. Use hoist or crane
capable of lifting compressor weight (See General Data).
Falling off the compressor can cause serious injury or death. Use ladder

Before Towing

Ensure the tires, wheels, and running gear are in good condition and secure.
• Use tow vehicle whose towing capacity is greater than the weight of the compressor
(See General Data).
• Do not tow the compressor in excess of the maximum towing speed (See General
Data).
• Place wheel chocks under tires and/or set parking brake before disconnecting from
towing vehicle.

Setting Up

Place the compressor in an open, well-ventilated area. Ensure there is sufficient clearance for
ventilation and exhaust requirements. Adequate clearance needs to be allowed around and
above the compressor to permit safe access for specified maintenance tasks.
Position as level as possible. Do not exceed the out-of-level operating limit (See General
Data).
When the compressor is to be operated out-of-level, it is important: (1) to keep the engine oil
level near the High level mark (with the compressor level), and (2) to have the Compressor Oil
Level Gauge show no more than mid-scale (with the compressor running at full load). Do not
overfill either the engine oil or the compressor oil.
Ensure that the compressor is positioned securely and on a stable foundation. Any risk of
movement should be removed by suitable means, especially to avoid strain on air discharge
piping.
Chock wheels and/or set parking brake.
Ensure all transport and packing materials are removed.
54
WARNING
!
and handholds to access lifting bail.
Operating Instructions