Flex DD 2G 10.8-EC Operating Instructions Manual page 22

Inserting/replacing the battery
 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
22
DD 2G 10.8-EC / PD 2G 10.8-EC
Direction preselection
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
 Move the direction preselector switch to
the required position:
– Left: counterclockwise (remove screws,
release screws)
– Right: clockwise (drill, insert screws,
tighten down screws)
– Middle: switch-on interlock (tool change,
when working on the power tool)
Operating mode (PD ... only)
CAUTION!
Change the operating mode only when the
power tool is stopped.
 Move the operating mode turning dial to
the required position.
: Drilling
: Screwing
: Impact drilling