Accessing And Using The Menus; States Menu; Setting The Overheating Setpoint; Active Alarm - Eliwell V800 Series Manual

ACCESSING AND USING THE MENUS

Resources are organised into menus and viewed by briefly tapping the 'set' key ('Machine state' menu) or by
keeping the 'set' key pressed for more than 5 seconds ('Programming' menu). Press the 'set' key once to view the
contents of any folder highlighted by the corresponding label.
At this point it will be possible to scroll through the contents of the folder and edit it or use the functions it con-
tains. Either do not press any keys for 15 seconds (time-out) or press the 'fnc' key once, to confirm the last value
displayed and return to the previous screen.
STATES MENU (SETPOINTS / PROBES / ALARMS)
To access the 'States' menu press and release the 'set' key.
If no alarms are active, the 'SEt' label appears. Use the 'UP' and 'DOWN' keys to scroll through the other resources
in the menu.

Setting the Overheating Setpoint

Press and release the 'set' key. The 'SEt' folder label appears. To display the Setpoint value press the 'set' key once
again. The Setpoint value appears on the display. To change the Setpoint value, press the 'UP' and 'DOWN' keys
within 15 seconds. If the parameter LOC = y the Setpoint cannot be modified.

Active alarm

Press and release the 'set' key. If there is an active alarm condition, the 'AL' folder label will appear (see 'Alarms'
section).

Probe display

When the corresponding label is displayed, pressing 'set' displays the value of the probe on the associated label.
17 - EN V800