Orbis CODITEL 2 User Manual page 42

RINGRISP [status] with status that can assume the values:
− ON  sends a text message to the caller on the response of the outputs to the ring
− OFF  no text message will be sent as reply
If the value is omitted, the current instrument status will be the reply.
• Defining the response to a ring (for admin only)
The response of the outputs to a ring from an enabled telephone number can be defined
through the command:
OUTRING [output number][output status][status holding time][unit of measurement],
− [output number] 
− [output status] 
− [status holding time] 
− [unit of measurement]  s seconds, m minutes, h hours (optional parameter)
Some examples:
OUTRING 1 ON
OUTRING 1 OFF 10 S
OUTRING 2 DISABLE
OUTRING 2 TOGGLE
• Setting the output status
To send more complex commands to the instrument, text messages must be used.
The possible commands are:
OUT [output number][output status][status holding time][unit of measurement],
− [output number] 
− [output status] 
− [status holding time] 
− [unit of measurement]  s seconds, m minutes, h hours (optional parameter)
Some examples:
OUT 1 OFF 10 S
OUT 2 ON 12 H
indicates the output to which reference is made (1 or 2)
can assume the values ON, OFF, TOGGLE, DISABLE
maximum time setting (2
opzionale)
the relay 1 is turned ON
the relay 1 is turned OFF for 10 seconds when the ring is
received
the relay 2 does not do anything when the ring is received
the relay 2 changes position when the ring is received
indicates the output to which reference is made (1 or 2)
can assume the values ON, OFF
maximum time setting (2
parameter)
sets the relay 1 OFF for 10 seconds
sets the relay 2 ON for 12 hours
- 40 -
User Manual CODITEL 2
-1) secondi (parametro
32
-1) seconds (optional
32