Orbis CODITEL 2 User Manual page 37

➢ Fix the cover
➢ Screw the supplied antenna into its connector on the side of the instrument.
Note: Ensure that the power cables are disconnected before replace the
antenna.
➢ Connect the power and the load as shown in the "wiring diagrams". Once the
instrument has been connected, the led
then the led begins to blinking once at second, indicating the correct reception of the
GSM network. If this is not the case, see box "Device status" pag. 34.
➢ STORE ADMIN NUMBER
For the proper functioning of the instrument it is necessary to set the number admin
who has full control of the instrument.
The first number to make a ring after the first start (or after a reset of the instrument)
will be stored as number admin.
– hold the "1–SET" button for 5 seconds until the led
red / green
– make a ring with the number you want to set as many admins.
The caller will receive an SMS confirmation of activation.
MANAGEMENT ENABLED NUMBERS
• Managing user numbers
You can create a phone book containing up to 2000 phone numbers (user numbers) the
which may act on the state of relay by sending SMS or phone rings.
There are two ways to add a user number:
− via phone ring
➢ Hold for 5 seconds the "Set" button until the led
red / green.
➢ Make a ring with the number concerned. This number will be inserted (removed)
from the list of user if not present (present) in the phonebook. An SMS
confirmation will be sent to caller with an indication of the phrases employed
total available.
will remain green fix for about 30 seconds;
- 35 -
User Manual CODITEL 2
begins to flash alternately
begins to flash alternating