Crown CT19022K Original Instructions Manual page 18

• Deflector nozzle 9 is used for treating one surface
and protecting the other (the heating of which is unde-
sirable, e�g� window glass)�
• Reflector nozzle 10 is used for changing the air flow
direction�
• Point nozzle 11 is for treating small-area surfaces as
well as for soldering�
General recommendations
• If necessary, put an appropriate special nozzle on
gun nozzle 1�
• Prepare accessories required for work performance
(scraper, palette knife, brush, etc�)�
• Switch on the power tool, adjust the air flow and
temperature as described above�
• After the operation completion, place on / off
switch 5 in position "1" and let the power tool run for a
while so that it cools down, and only after that you can
switch it off�
Special recommendations for performing different
types of work (see fig. 4-8)
Paint and coatings removal (see fig. 4) - install
flat nozzle 8, heat the surface area until the coat-
ing softens, and remove it with a palette knife or
scraper 7�
Lacquer and paint coatings removal from window
frames (see fig. 5) - install deflector nozzle 9 correctly
(to protect the glass), heat the surface area until the
coating softens, and remove it with a palette knife or
scraper 7�
Forming plastic pipes (see fig. 6) - install reflector
nozzle 10� Fill the plastic pipe with sand and close it
at both ends to prevent pipe collapse� While moving
the pipe in the hot air flow, heat it and mould it as
required�
Thawing water pipes (see fig. 7) - install reflector
nozzle 10� While moving the power tool, heat a frozen
area from the edge to the middle� While heating plastic
pipes, be careful not to overheat them�
Soldering (see fig. 8) - install point nozzle 11� Apply
solder paste on the soldering area� Depending on the
material, heat the soldering area for 50-120 seconds,
and then apply solder alloy� The solder alloy must melt
under the workpiece temperature�
The manufacturer reserves the possibility to introduce changes.
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Taking care of accessories
Keep special nozzles and scraper 7 clean - remove all
materials stuck to them� Regularly sharpen the blade
of scraper 7 - this will facilitate the work and improve
its results�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 4�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com�
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Environmental protection
Recycle
disposing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
18
raw materials instead of