Landis+Gyr FOCUS KWH Technical Manual page 9

(3) For RF exposure, service personnel are to maintain a minimum of 20cm from the
RF communications transmitter once installed.
Changes or modifications not expressly approved by Landis+Gyr could void
the user's authority to operate the equipment.
Do not change the original antenna without pre-approval from the original
meter manufacturer. This will violate the FCC regulations of using the
radio.
Note:
Some Focus meters may contain AMR modules with RF communications. This equipment
has been tested and found to comply with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-
-
-
-
Following are FCC identification numbers for radio systems currently used on FOCUS:
StatSignal FCC ID: ROV-1MWR9165
Cellnet FCC ID: ROV-CLTR900M
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult Landis+Gyr or an authorized technician for help.
viii viii