Compaq iPAQ MP3800 User Manual page 58

Troubleshooting (Continued)
Problem
Only the Compaq startup screen
displays.
A blue screen displays on the
projection screen when a
videocassette recorder, DVD
player, or other video source is
connected to the projector.
Screen is dimmer than normal.
Lamp shuts off.
Compaq iPAQ Microportable Projector MP3800 User's Guide
Solutions
1. Check that the cables are connected
securely.
2. Verify that the proper input source is
connected.
3. Make sure your notebook
computer's external video port is
activated.
1. Check the Play or TV/Video buttons
on the video source.
2. If that does not work, refer to the
owner's manual that came with the
video source.
The projector is in lamp saver mode.
Press the lamp saver button on the top of
the projector to turn lamp saver on or off.
If the LED is green, lamp saver is on. If
the LED is not lit, lamp saver is off.
1. If the Standby LED flashes green
rapidly, the projector has overheated
and will automatically shut down.
Wait five to ten minutes until the LED
stops flashing and the
Power/Standby
before restarting the projector again.
2. A minor power surge may cause the
lamp to shut off. Wait a few minutes,
then turn it back on.
3. When the lamp has reached the end
of its life, the system will
automatically turn off to prevent
possible lamp rupture. Replace the
lamp as described in the "Replacing
the Projector Lamp Module" section
of Chapter 7.
Troubleshooting
button turns amber
8–5