Removing A Network Module; Finding The Network Module Serial Number - Cisco Catalyst C9200L-48PXG-4X-E Hardware Installation Manual

Removing a Network Module

Removing a Network Module
Note The switch complies with EMC, safety, and thermal specifications when a network module is present. If no
uplink ports are required, install a blank network module.
Note To avoid authentication failure and non-detection of modules, wait for a minimum of 6-8 seconds between
the online insertion and removal (OIR) of network modules.
Procedure
Step 1 Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface
Caution
Caution
Step 2 Disconnect the cables from the pluggable transceiver module.
Step 3
Remove the pluggable transceiver module from the network module.
Step 4 Loosen the captive screws that hold the network module in place until it completely disengages from the
chassis.
Step 5 Carefully slide the network module out of the slot.
Step 6
Install a replacement network module or a blank module in the slot.
Step 7 Place the module that you removed in an antistatic bag or other protective environment.

Finding the Network Module Serial Number

If you contact Cisco Technical Assistance regarding a network module, you need to know its serial number.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
36
Do not remove the network module with connected cables or installed pluggable transceiver modules.
Always remove any cables and modules before you remove the network module.
A module interface might become error-disabled when a network module with connected fiber-optic
cables is installed or removed. If an interface is error-disabled, you can reenable the interface by
using the shutdown and no shutdown interface configuration commands.
Installing a Network Module