Table of Contents
Advertisement
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
Pointing the EMP to the Controlling Cisco Unified
Videoconferencing 3515 MCU
You can use the serial port to point the EMP to the IP address of the controlling Cisco Unified
Videoconferencing 3515 MCU unit.
Procedure
At the prompt, enter M to change the Cisco Unified Videoconferencing 3515 MCU IP address and press
Step 1
Enter.
The Cisco Unified Videoconferencing 3515 MCU IP address screen displays as follows:
Enter the IP address of the Cisco Unified Videoconferencing 3515 MCU and press any key to return to
Step 2
the EMP Main menu.
Changing Advanced Configuration Settings
You can use the serial port to change these advanced configuration settings:
•
•
•
•
Procedure
At the prompt, enter A to access the Advanced Configuration menu.
Step 1
The Advanced Configuration menu appears as follows:
At the prompt, enter 1 to configure the web server port.
Step 2
The current web port server setting displays.
Step 3
At the prompt, enter 2 to restore the factory configuration settings.
You are asked to confirm your choice as follows:
Enter y or n.
Step 4
Step 5
At the prompt, enter 3 to change Ethernet speed and duplex parameters.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7
OL-17012-01
Enter MCU ip address
Without leading zeros <current IP address>:
Web server port (for future use)
Restore factory configuration (for future use)
LAN port settings
Disable DSP reset
Advanced configuration menu
Q: Quit
1: Configure web server port
2: Restore factory configuration
3: Change Lan port Settings
4: Disable DSP reset
Select:
Select: 2
Are you sure you want to restore factory configuration? [y, n]:
How to Perform the Video Processing Module Initial Configuration
2-11
Advertisement
Table of Contents
