Table of Contents
Advertisement
How to Perform the Video Processing Module Initial Configuration
•
•
Connecting the Cisco Unified Videoconferencing 3515 MCU Unit to the LAN
Procedure
Step 1
Connect the supplied LAN cable from your network switch to the 10/100BaseT Ethernet port on the front
panel of the Cisco Unified Videoconferencing 3515 MCU unit. The 10/100BaseT port accepts an RJ-45
connector.
Turn on the power to the Cisco Unified Videoconferencing 3515 MCU unit.
Step 2
How to Perform the Video Processing Module Initial
Configuration
•
•
•
•
•
•
•
•
•
About the Initial Video Processing Module Configuration
You must also configure an IP address for the video processing module. The IP address of the video
processing module must be different than the IP address configured for the Cisco Unified
Videoconferencing 3515 MCU unit.
Initial monitoring and administration of the video processing module are performed from a remote PC
using a terminal emulation application, such as HyperTerminal. To make the serial connection, connect
a PC terminal to the lower serial port on the front panel of the Cisco Unified
Videoconferencing 3515 MCU unit as described in the
serial configuration utility runs as a target configuration service. You can use the serial configuration
utility to:
•
•
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7
2-8
Enter the letter for the set of parameters that you want to configure.
Enter Q to save your changes and allow the device to complete the boot process.
About the Initial Video Processing Module Configuration, page 2-8
Accessing the Video Processing Module Main Menu, page 2-9
Setting the IP Address, page 2-9
Changing the Configuration Software Password, page 2-10
Changing the Security Level, page 2-10
Pointing the EMP to the Controlling Cisco Unified Videoconferencing 3515 MCU, page 2-11
Changing Advanced Configuration Settings, page 2-11
Saving Network Configuration Settings, page 2-12
Connecting the EMP to the LAN, page 2-12
Configure default network port values.
Modify the configuration software password.
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
"Connecting to a PC" section on page
2-5. The
OL-17012-01
Advertisement
Table of Contents
