PEERLESS SAL730P Installation And Assembly Manual page 9

Note: If the ball joint feels loose
3
or too easy to adjust, slightly
tighten cap socket screw until
ball joint feels firmly in place.
Insert two M5 x 10 mm screws
(F) into top two holes of adapter
plate (B) leaving about 1/4" of
exposed thread. With slots
facing upward, hook screws
onto wall arm ball joint as
shown in figure 3.1.
Insert one M5 screw (F) through
bottom hole of wall arm ball joint
into adapter plate (B) as shown
in figure 3.2.
Ball join design at screen for
easy side-to-side movement
and ±35° of tilt.
Route cords through center of cord management clip (L). Next, attach cord management clip to wall arm ball joint
4
using M5 screw (F) as shown. Tighten all four screws (F).
Note: A cord management clip (L) was added for additional cords. If you want to use this added clip, remove the
opposite bottom screw and repeat this step on opposite side of wall arm ball joint.
L
fig. 3.1
F
B
WALL ARM
BALL JOINT
WALL ARM
BALL JOINT
F
9 of 30
1/4"
CAP SOCKET
SCREW
F
ISSUED: 06-10-05 SHEET #: 095-9223-4 08-30-05
fig. 3.2
B