Dometic Oceanair Skysol Track Small Manual Installation And Operating Manual page 14

Installation
7.4 Installing the cord plugs (only for manual blinds)
➤ Check the operation of the blind by moving fully to the top and to the bot-
tom.
If the blind is properly adjusted, it should hold in all positions in between and
operate with ease.
• If the blind falls down on its own, the cords need to be shortened. The easiest
way to do this is at the bottom end plugs by pulling out the plug and tying a
new double knot. Both cords need to be adjusted evenly. Shorten the excess
cord only after you have thoroughly tested the blind.
• Make sure the springs in the head rail is not pulled to one end of the head rail,
but is approximately in the middle. If it is not, the tensioning does not work
properly.
8
1.
7.5 Connecting the blinds (only for powered blinds)
The electrical power supply must be connected by a qualified electrician who
has demonstrated skill and knowledge related to the construction and opera-
tion of electrical equipment and installations and has received safety training to
identify and avoid the hazards involved.
The powered blinds are available for a connection to a 12/24 Vg power supply.
The data plate on the head rail provides important information on the specifica-
tions of the motor.
14
Skysol Track Small
2.
3.
4.
EN