Assa Abloy Alarm Controls KP-400 Operating Instructions Manual page 6

DOOR FORCED OPEN ALARM (CONTINUED)
To disable the Door Forced Open Alarm feature -
1. Put the keypad in Program Mode by entering the Installer Code followed by
the "". The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter "8 0 0 #".
3. Enter "" to exit Program Mode. The yellow LED will begin blinking.
If the door is left open for longer than a preset time, the keypad will generate an
alarm until the door is closed. The door open time can be programmed from 1 to
999 seconds. Door position is monitored via the Door Position Sensor Input.
1. Put the keypad in Program Mode by entering the Installer Code followed by
the "". The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter "9 (door open time 1-999) #".
3. Enter "" to exit Program Mode. The yellow LED will begin blinking.
To disable the Door Propped Open Alarm feature -
1. Put the keypad in Program Mode by entering the Installer Code followed by
the "". The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter "9 0 #".
3. Enter "" to exit Program Mode. The yellow LED will begin blinking.
MOMENTARY OR LATCHING OUTPUT MODES
Outputs 1 and 2 can be programmed for either momentary or latching operation.
Momentary operation time can be set for between 1 and 999 seconds. The
factory default momentary operation time is 2 seconds.
1. Put the keypad in Program Mode by entering the Installer Code followed by
the "". The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Output 1 Momentary Mode -
Enter "4 0 (output active time 1-999) #"
Output 2 Momentary Mode -
Enter "5 0 (output active time 1-999) #"
Output 1 Latching Mode -
Enter "4 1 #"
Output 2 Latching Mode -
Enter "5 1 #"
3. Enter "" to exit Program Mode. The yellow LED will begin blinking.
DOOR PROPPED OPEN ALARM
6